Nordic Ware round cake tin Springform, diameter 23 cm, volume 2,4 l
Cake mould with easy release side wall with clip. Made of carbon steel with non-stick surface.
- Material: carbon steel, non-stick surface
- Colour: silver grey
-Diameter: 23 cm
- Capacity: 2,4 l (10 cup)
Perfect result at all times
The mould is made of carbon steel, which distributes the heat evenly over its entire surface. Thanks to the easy release of the side wall with a clip, you can also easily handle the baked cake body.
Maintenance instructions:
- Before first use and after each subsequent use, wash by hand with warm soapy water using a sponge.
- We recommend using nylon, wooden or silicone tools and cleaning aids. Metal tools and scouring pads will scratch the steel plate, may cause small dents in the plate and may cause corrosion with prolonged use.
- It can be washed in the dishwasher, but always ensure that the mould is thoroughly dried before storing it.
- Before each use, grease the mould with butter, lard, table oil or recommended spray, or line it with baking paper.
The human touch
Nordic Ware's beautiful cake moulds and other products are made with visible care . care , and this is also due to the fact that the production process also involves hand-working. Nordic Ware has been perfecting the process of creating unique bundt cakes for over 70 years, so that the moulds are not only unique but also perfectly functional.
Material
The aluminium used to make the moulds is first melted at a temperature of 650°C and thenthen flows as a liquid into a holding chamber where a pressure arm pushes the liquid aluminium into the mould.This process has to be fast because it only takes a few seconds for the aluminium to solidify. The mould is then opened and the very hot but solid aluminium mould can be removed. Aluminium is very malleable, so Nordic Ware moulds can be shaped to the smallest detail.
Surface
Once the mould has been cast to the appropriate shape, it still has a long way to go, the next step is to trim the excess aluminium around the perimeter of the mould. The mould is then sent for further processing, where it goes through a series of finishing processes, includingvibratory deburring, corrosion protection spraying and surface roughening. The mould is then thoroughly washed, sprayed with a non-stick surface coating and cured using a PFOA-free resin .
